Advantages of Air Plasma cutting machines are:

• No more oxy / fuel for cutting all ferrous and non ferrous metal.
• Double the speed at half the cost.
•  No heat effect zone, no distortion.
• No cumbersome fuel ignition, preheat flame adjustment, preheat Time or oxygen adjustment required.

The technical specifications of these models are shown below.

 

MODEL NO.	MPT-30	MPT-40	MPT-50
Primary Voltage	380 - 440V 3Phase-50 Hz	380-440 V 3 Phase-50Hz	380-440 V 3Phase-50 Hz
Secondary Voltage	260-280V	260-280V	260-280 V
Line Current	44 Amp.	60 Amp.	63 Amp.
Arc Current	100 Amp.	135 Amp.	155 Amp.
O.C.V (No load)	300-320 VDC	300-320 VDC	300-320 VDC
Power Rating	31.0 KVA	42.0 KVA	44.0 KVA
Insulation	F class	F class	F class
Duty cycle	100% at Full load current of 100 Amp.	100% at Full load current of 135 Amp.	100% at Full load current of 155 Amp.
Cutting Capacity for SS Clean Cut for SS Parting Cut	35mm 40mm	45mm 50mm	55mm 60mm

 

MODEL NO.	MPT-50(W) STEP	MPT-75(W) STEP	MPT-100(W) STEP
Primary Voltage	380-440 V 3Phase- 50Hz	380-440 V 3Phase-50Hz	380-440 V 3Phase-50Hz
Secondary Voltage	260-280 V	260-280 V	260-280 V
Line Current	70 Amp.	90 Amp.	120 Amp.
Arc Current	100 Amp. 200 Amp.	125 Amp. 250 Amp.	150 Amp. 300 Amp.
O.C.V (No load)	300-320 VDC	300-320 VDC	300-320 VDC
Power rating	49.0 KVA	63.0 KVA	84.0 KVA
Insulation	F class	F class	F class
Duty Cycle	100% at Full load current of 200 Amp.	100% of Full load current of 250 Amp.	100% at Full load current of 300 Amp.
Cutting Capacity For SS Clean Cut For SS Parting Cut	55mm 60mm	75mm 80mm	100mm 105mm

Special Machine Features

• The cutting process is carried out by using shopfloor compressed air. Thus the process becomes cheap and flexible. The unique pilot arc system ensures perfect arc start on painted and rusted surface.
• An electro-pneumatic protection cuts the arc in case of insufficient air supply adding to the safety of the machine and torch.
• Specially designed power source for 100% duty cycle.
• Quality epoxy powder coating for longer lasting effect.