• Superior Welding Quality With IGBT Based Inverter Power Source Works on Single Phase.
• Electronic High Frequency . Start.

• High Open Circuit Voltage for Good ARC Striking  and for Good    Welding Quality

• Low Gas, No Water & High Temp. protection
• Up Slope/Down Slope & Pulsing On/Off Selectivity.
• Stepless Setting For Welding Current as Well as for Pilot.
• Welding Current Can be Set Locally or With Remote Control
• Actual Welding Current & Pilot Arc Current can be Seen on Front Panel Digital Display

• Equipped With pre Flow, Post Flow, up Slope, Down Slope Base Current  as well as Pulsing Current Controls

• Logic Fail Protection (Ensures IGBT Safety.)

• High Efficiency More than 92%

• AAT Mode( Auto Arc Transfer) Facility.

• 2T/4T Mode Selectivity.
• Weld Time Set Facility on Request

The technical specifications of these models are shown below.

Micro Plasma Welding Power Source

MODEL NO.	Klein Schweisser 50 Micro Plasma
Power source	IGBT Based Inverter Supply 1 phase 50 HZ
Input Supply	220 Volts A/C , 1 Phase, 50 Hz
Main ARC Open Circuit Voltage	100 VDC. Max
Main ARC Current	0.5 Amp to 50 Amps. DC
Pilot ARC Open Circuit Voltage	< 100 Volts DC
Pilot ARC Current	1 Amp to 5 Amps. DC.
ARC Starter	Electronic High Frequency
Class of Insulation	H Class
Cooling	Forced Air Cooled With Fod System
Protection	IP 21
Pilot Gas Supply	Argon, 25 Psi at 0.1 to 1.0 lit/min
Shilding Gas Supply	25 Psi at 1 to 8 lit/min pure Argon or Various mixtures as determined by desired Arc characteristics & metallurgy of the work material

 Micro Plasma Welding Torch

Main Current Capacity	1 to 25 Amps
Pilot Arc Current Capacity	1 to 5 Amps
Tungsten Size	1.00 mm to2.4 mm dia
Nozzle Size	1.0mm, 1.2mm 1. mm 1.8mm dia
Cooling	Water Cool
Cable Length	3 meters